-36-
17. Setting and checking via IVR
User could get or set some parameters of the system by dialing in the
mobile numbers of the device.
The status or result is reported via
voice response system. In the first 20 seconds after power-on (when
only Mobile light flash), you could dial its mobile numbers. When you
hear the dial tone, press the following codes to set or check the device.
Item Function Code Action
1 Reboot #195#
Reboot the device
2 Factory Reset #198#
Return to default settings
3 Check IP Address #120# IVR announces the current IP
address. Default: 192.168.0.100
4 Check IP Type #121# IVR announces DHCP is on or off.
Default: off
5 Check Network
Mask
#123# IVR announces the current network
mask. Default: 255.255.255.0
6 Check Gateway
IP Address
#124# IVR announces the current gateway
IP address. Default: 192.168.0.254
7 Check Primary
DNS Server
#125#
IVR announces the current setting in
the Primary DNS field.
Default: 192.168.0.1
8 Check Firmware
Version
#128#
IVR announces the version of the
firmware.
9 Set as DHCP
client
#111#
The system is changed to DHCP
Client type
10 Set Static IP
Address
#112xxx*xx
x*xxx*xxx#
DHCP is disable and system is
changed to static IP type.
Enter IP address using numbers on
the telephone keypad. Use the *
(star) key when entering a decimal
point.
11 Set Network Mask #113xxx*xx Must set Static IP first.
To Next Page
Loading...
