26525-01A
12
are and Maintenance
Cleaning After Use
Clean and disinfect your tanning bed’s
bench and canopy after each use. Use a
non-abrasive disinfectant cleaner that does
not contain ammonia or ammonia deriva-
tives. Ammonia may damage the acrylic
shields. Spray the acrylic lightly with disin-
fectant and wipe dry with a clean soft cloth.
We recommend Australian Gold® PH
Neutral disinfectant cleaner.
Thorough Periodic Cleaning
Introduction
The cooling fans draw air through the bed
and over time will cause a dust buildup on
the lamps and reflectors. This will reduce
the tanning effectiveness of the bed. When
a dust buildup is observed, it is necessary to
thoroughly clean the inside of the bench
and canopy.
Cleaning the Canopy and Bench
1. Remove the acrylic shields and lamps as
described in Replacing Lamps.
2. With a soft cloth, wipe the entire length
of each lamp to remove any film buildup.
3. Clean both sides of the acrylic shields
with a non-ammonia disinfectant cleaner.
4. Wipe the reflectors with a clean damp
cloth.
5. Re-install the lamps and acrylic shields.
Mechanical Inspection
Your tanning bed has been built for years of
service. To ensure trouble-free operation
throughout its life, inspect the unit’s
mechanical integrity every 400-500 hours
of use.
•Inspect the unit’s fasteners verifying
that all are firmly in place. Pay partic-
ular attention to the hinge bolts.
• Inspect gas springs for signs of wear.
Gas springs that will not hold the
canopy in the full open position when
raised should be immediately replaced.
•Inspect the timer as indicated in this
manual under Timer Maintenance.
•Inspect the AC power cord and its con-
nections.
•Inspect the acrylic. Broken, cracked or
badly scratched acrylics should be
immediately replaced.
WARNING
Shock hazard.
Disconnect power before removing
any protective covers.
To Next Page
Loading...