Sunquest PRO 24RSF - Pre-Installation Planning

2
Installation - Pre-Installation Planning
26525-01A
Pre-Installation Planning
Before you begin to assemble your sunbed, you should observe the following pre-
installation considerations.
• Your sunbed operates from a 220V
AC source. You should have a NEMA
6-20R electrical outlet (like the one
shown below) installed in the room
in which you will use the unit. The
outlet should be on a dedicated cir-
cuit capable of providing 20 Amp
service. W
e recommend installation
by a professional electrician. The
outlet must be earth grounded.
20 AMP NEMA #6-20R RECEPTACLE
WARNING
Shock hazard.
Disconnect power before servicing.
Air from the room is used to cool
the sunbed. Maximum ambient
room temperature should be 80°F.
Place your sunbed no closer than
6” from any wall. Make sure nothing
obstructs the airflow into the
sunbed’s endcaps or out of the fan
openings. A poorly ventilated room
may cause the unit to become hot
and cause discomfort to the user.
CAUTION
Use of a voltage source above 230V
AC may prevent proper operation of
the sunbed and could cause damage
and void the warranty.
CAUTION
Proper assembly of your sunbed
requires three people. Plan to have
a couple of helpers assist you.
CAUTION