26525-01A
13
Care and Maintenance - Replacing Lamps
Replacing Lamps
Introduction
To be assured of maximum tanning effec-
tiveness, change lamps after approximate-
ly 800-1000 hours of use. Tanning will
continue after this time but at a slower
rate. To ensure trouble-free operation of
your sunbed, replace the lamp starters
whenever the lamps are replaced.
Removing/Replacing Acrylic Shield
The acrylic shields in the bench and
canopy are secured in place by hinged
profiles which run the length of the bed,
both front and back. Simply pry up on the
inside edge of the profile until it releases
its latching action (see figure at right).
Continue to pry up the profile across its
entire length until it swings back freely.
Repeat for the other profile. The long edges
of the acrylic shield are now exposed.
Standing in front of the sunbed, grasp the
exposed edge of the acrylic and carefully
slide it toward you until it is removed.
After changing the lamps, replace the
acrylic shields by reversing the above
directions. Close the hinged profile by
pushing it back into place until it snaps
tight.
PROFILE
Start pulling from the
middle of the profile!
CAUTION
Be careful. The edges of the acrylic
shield may be sharp.
WARNING
Shock hazard.
Disconnect power before servicing.
To Next Page
Loading...
