26525-01A
14
Care and Maintenance - Replacing Lamps
Removing/Replacing Lamps
After removing the acrylic shields, replace
lamps as follows.
Step 1 Grasp a lamp at one end and at
the middle, then turn the lamp a
quarter turn. The lamp may then
be gently removed from its
holder.
Step 2 To reinstall a lamp, insert the
pins located on the ends of the
lamp into the slots on top of the
lamp holder and turn the lamp a
quarter turn.
Recommended Replacement Lamps
We recommend using the lamps specified
below. Use of uncertified lamps is a viola-
tion of Federal regulations and will void
your warranty. These lamps have an aver-
age life of 800-1000 hours of effective
tanning use. Lamps used longer than that
begin to lose their effectiveness even
though they will continue to light.
THE FOLLOWING LAMPS HAVE BEEN CERTIFIED FOR USE IN THE RS MODEL SERIES:
GT Wolff® Model GT171-T12-100W BI-PIN
GOLDEN TAN™ Wolff® Model GT71-T12-100W BI-PIN
THE FOLLOWING LAMPS HAVE BEEN CERTIFIED FOR USE IN THE 24RSF:
GT Wolff® Model GT159-T12-80W-BI-PIN (Short Lamps)
GT Wolff® Model GT171-T12-100W BI-PIN (Full-length lamps)
GOLDEN TAN™ Wolff® Model GT59-T12-80W BI-PIN (Short Lamps)
GOLDEN TAN™ Wolff® Model GT71-T12-100W BI-PIN (Full-length lamps)
Heraeus E400 HPT, Philips Model HPA 400/30s or CosmoTech Model 23045
(SolarMax™ IFT Face tanner unit)
WARNING
Shock hazard.
Disconnect power before servicing.
To Next Page
Loading...
