26525-01A
Parts List
This is a list of parts which may be replaced by the
consumer. Care should be taken when replacing
anything related to electrical wiring. We recom-
mend contacting a professional electrician. When
calling for parts, first state your bed model as N2-
24RS, N2-24RSF or N-26RS. Then refer to this list
and preceding illustrations for proper part identifi-
cation.
Acrylic, Bench*
Acrylic, Canopy*
Ballast, 80W*
(for short lamps on 24SF)
Ballast, 100W (1 for each main lamp, 4 for
each face tanner lamp)
Capacitor, 75uF
Contactor (Relay)
Cover, Bench
Cover, Canopy
Endcap Kit
(1 left and 1 right endcap)
Fan
Gas Spring set
Hardware Kit*
(assembly hardware)
Hinge Brackets (left and right)
Keys, Parental Lock*
Lamp Holder w/ Starter*
Lamp Holder w/o Starter
Lamp Holder, Face Tanner*
Lamps
Leg Mounts*
(found inside the bench)
Legs
Manual*
Pillow*
Profile
(blank)
Redundant Timer
Schematic Packet*
CALL FOR SERVICE OR QUESTIONS: 1•800•449•3605
ETS, Inc. 6270 Corporate Drive, Indianapolis, IN 46278-2900
Record this information for ease of service:
Date of purchase:
Bench serial number:
Canopy serial number:
Silk-screened Profile
Starter, K-11*
(main lamps)
Starter, Face Tanner*
(ignitor)
Switch, Face Tanner
Switch, Parental Lock
Thermostat, Face Tanner*
Timer
Timer Bezel
Timer Knob
Trim Profile
(blue)
* Not shown
To Next Page
Loading...
