3.
awnings greater than 16’, you should use three chairs
to support the Roller Bar during this process.
4. Remove the Roller Bar from the cardboard tube.
Separate the Awning Rail from the Roller Bar and
when facing the house. See .
Unit
6. Remove the Awning Fabric from the cardboard
tube. Pull back
so that
the opening is aligned with the Fabric Slot indicated
.
the end of the
Rolled up Fabric.
Fabric
set it aside.
Slide the Fabric the rest of the way onto the Roller
edge of the Fabric. Tighten the Fabric Stop with the
then Fabric, in
Fabric Slot
8.
into this Slot. Slide the Fabric Stop to
the opposite end of the Roller Bar and
9.
with the edge of the Fabric. See .
Side
Right
Side
Fabric Stop
end of the Roller Bar. Be sure that the Hem of the
Fabric is facing down while the Fabric is toward the
house. See .
Fabric Stop
Both Hem-Folds
in Hem.
Rolled
Fabric
Roller Bar
Fabric
To Next Page
Loading...
