Your Installer has programmed your EasyScreen(s) to operate on one or more channel(s) of your Remote.
Test the operation of your EasyScreen by using the UP and DOWN buttons on the Remote.
• Press and release the UP button. The EasyScreen will roll up to the Cassette Hood and stop on its
own. The UPPER stop limit should stop the EasyScreen automatically, before the Hem Bar reaches the
Hood. See Appendix A to adjust the UPPER stop limit.
• Press and release the DOWN button. The EasyScreen will unroll from the Cassette Hood and stop on
its own. The LOWER stop limit should stop the EasyScreen automatically, before the Hem Bar reaches
the physical limit of the ground/deck. See Appendix A to adjust the LOWER stop limit.
Your EasyScreen Motor has an obstacle detection feature. If an obstacle is detected during movement, the
Motor will stop automatically. Check to make sure there are no obstacles while the Screen is opening that
may be causing the Motor to stop. Once obstacles are removed, press the UP button briefly, followed by the
DOWN button. The Screen should now open fully to its lower stop limit.
High winds can apply enough tension to the Screen to activate the obstacle detection feature. If the Screen
continues to stop while lowering, wait for the wind to settle down, and try lowering again.
Depenidng on Remote model(s) ordered, you may have one or more Single Channel Remote(s) or Multi-
Channel Remote(s). If you own more than one Remote and/or EasyScreen, it is recommended to label the
Remotes and/or EasyScreens to prevent mix-ups.
Each Remote and each Channel (if applicable) of each Remote has its own unique ID.
If you have ordered a Multi-Channel Remote, it is recommended to use Channel 1 (the rst light from the left)
of the Remote to control the EasyScreen. Channel 1 of each Remote is unique from Channel 1 of every other
Remote.
To control multiple EasyScreens with one or more Remotes or Channels, or to mix and match Remotes with
more than one EasyScreen, see Appendix C.
Each LED light represents a separate
Channel with its own unique ID, which
operates as a unique Remote.
Channel 1 is the rst light on the left.
Channel Selector Button
Press and release; the active Channel LED
will blink.
Press while the active Channel LED blinks,
next Channel selected and blinks.
To Next Page
Loading...