For Technical Support visit us at www.sunseer.com/ownerscorner
or Call Toll Free 800-670-7071 • Fax 877-224-4944
©SunSeer Products, a Massachuses Limited Partnership, 184 Charles Street, Malden, MA 02148
EASYSHADE®
Solar Powered Motorized EasyShade®
Motor Replacement Instrucons
* Helper Needed *
Tools Needed:
Parts Supplied: Replacement motor
5. Coil the Vinyl Coated cable and secure with a piece
of masking tape.
See Figure 3.
Note: Step 6 requires access to the Mounng
Brackets for removal of the Housing. If the Fabric
Panel can not be retracted, have a helper assist
you in rolling the Fabric Panel around the boom
Leading Bar unl the rolled up Fabric and Leading
Bar meet the Housing, then secure safely in place.
6. While your helper supports the EasyShade, loosen
aid of your helper remove the EasyShade from the
brackets and place it carefully in your work area.
7. On the end of the Housing opposite the motor,
remove the two Phillips head screws that secure the
end plate to the housing. Remove the end plate and
the white nylon insert from the roller bar and place
aside for use in reassembly.
Figure 2
Figure 3
1. Close your EasyShade completely, if possible.
2. Disconnect the Power Cord from the Solar Panel.
the Vinyl Coated cable on each side of the EasyShade
See Figure 1.
4. Pull the Vinyl Coated Cable out of the guide holes
in each end of the EasyShade drop down panel.
See Figure 2.
Figure 1
Cable Guide Stop
Cable Guide
Guide Hole
Vinyl Coated
Cable
Masking
Tape
Vinyl Coated
Cable
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN PERSONAL INJURY!
PLEASE READ THESE INSTRUCTIONS COMPLETELY BEFORE PERFORMING THIS PROCEDURE.
Housing
Fabric Panel
To Next Page
Need help?
General
