SunSetter EASYSHADE Replacement Instructions

2
8. On the motor end of the housing remove the two
Phillips head screws that secure the end plate to the
housing. Pull the end plate/motor and the roller bar
about 6 inches out of the Housing. While holding the
roller bar, pull the end plate/motor out of the roller
bar. See Figure 4.
Note: Before preforming Step 9, take a moment
to observe the orientaon of the motor on the
housing end plate.
9. Using a 3mm Allen wrench, remove the two screws
that secure the Housing end plate to the motor.
See Figure 5.
10. Install the end plate removed in Step 9 on the
replacement motor.
11. Slide the motor into the end of the roller bar, with
the motor aligned with the notch cut in the end of the
roller bar. See Figure 6.
Figure 4
Figure 5
Figure 6
Notch Locking
Tabs
12. Rotate the motor to align the motor locking collar
with the notch on the roller bar (see Figure 7) and
while holding the roller bar push the motor into the

Note: The motor cord has a small white plasc cord
protector just below the motor head.
See Figure 8.
13. Align the cord protector so that the open side
will be facing the end of the housing and push the
cord and the cord protector into the notch on the
end of the housing.
See Figure 8.
14. On the motor end, make sure that the vinyl coated
Figure 8a)
Align the end plate with the housing and install the
two Phillips head screws to secure it in place.
15. Locate the end plate and the nylon roller bar
insert for the other end of the easyshade.
Figure 7
Notch
Locking Tabs
Figure 8aFigure 8
Open
End
Cord
Protector
Cord
Protector
Notch
Vinyl
Coated
Cable
Vinyl
Coated
Cable
Cord not
shown here.

SunSetter EASYSHADE Specifications

General

Brand	SunSetter
Model	EASYSHADE
Category	Accessories
Language	English