For Technical Support visit us at ownerscorner.sunseer.com
or Call Toll Free 800-670-7071 • Fax 877-224-4944
©SunSeer Products, 184 Charles Street, Malden, MA 02148
EASYSHADE®
1. Close your EasyShade completely, if possible.
2. Disconnect the Power Cord from the Solar Panel.
Solar Panel Assembly
Replacement Instrucons
* Helper Needed *
Tools Needed:
Parts Supplied: Replacement motor
4. Pull the Vinyl Coated Cable out of the Guide Holes
in each end of the EasyShade drop down panel.
See Figure 3.
Figure 2
Cable Guide Stop
Cable Guide
Bracket
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN PERSONAL INJURY!
PLEASE READ THESE INSTRUCTIONS COMPLETELY BEFORE PERFORMING THIS PROCEDURE.
Figure 4
Masking
Tape
Vinyl Coated
Cable
Leading Bar
Housing
Figure 3
Guide Hole
Vinyl Coated
Cable
Fabric Panel
3.
of the Vinyl Coated cables, on each side of the
Figure 2.
5. Coil the Vinyl Coated cable and secure with a
piece of masking tape. See Figure 4.
Figure 1
Note: If a Remote Wall Bracket (see
Figure 1) is used to mount the Solar Panel
direct to the wall (see Figure 2) instead
of mounng directly on the EasyShade
Housing, skip ahead to Appendix A.
Figure 2
Solar Panel
Allen Head
Set Screw
is located
below here.
Remote Wall Bracket
Note: Step 6 requires access to the Mounng
Brackets for removal of the Housing from the house.
If the Fabric Panel can not be retracted out of the
way, have a helper assist you in rolling the Fabric
Panel around the boom Leading Bar unl the rolled
up Fabric and Leading Bar meet the Housing, then
secure it safely in place.
To Next Page
Need help?
General
