19
9) How to wind the lower thread
A. Press SELECT on operation box and select .
B. Insert the bobbin into the thread winder drive shaft ② on thread winder base ①, attched to the
upper cap.
C. Adhere the bobbin winder lever ③ closely to a bobbin, then let the machine run by pressing pedal.
D. After the bobbin winder lever takes off from a bobbin, cut the thread of bobbin by using bobbin
winder knife ④.
[ Fig. 25 ]
10)
How to operate a pedal
A. Install a pedal switch in the proper position
for the convenience of work.
B. If you step on pedal one step, the button
clamp descends, and if take off your feet
from the pedal, it ascends.
C. If you step on two step the pedal switch
after stepping on it one step, the sewing
starts, and after finishing it,the button clamp
ascends.
[ Fig. 26 ]
[ Fig. 27 ]
11) Disposing the waste oil
When the oil receiving oiler at the bottom of
the table is full, take it off to empty.
↓
→
Oiler
Spread out some fabrics or papers
on the floor when you attach or
remove the oil receiving container.
Caution
To Next Page
Loading...
Need help?
General
