11
44
[ Fig. 1 ]
[ Fig. 2 ]
B. In case of SPS/C-B1202 series, attach the
bed cushion rubber to the table.
③
④
②
①
MACHINE INSTALLATION
1) Machine installation conditions
A. Do not use the machine where the voltage is over regular voltage ±10% to prevent accidents.
B. For safe operation of the machine, use the machine under the following conditions.
Surrounding Temperature During Operation : 5℃~40℃
Surrounding Temperature During Maintenance : -10℃~60℃
C. Humidity : Between 20~80%(Relative humidit
y)
2) Electric installation conditions
A. Power Voltage
·The power voltage must be between regular voltage ±10%.
·The frequency of the power should be regular frequency (50/60HZ)±1%.
B. Electromagnetic Wave Noise
Use separate power with strong magnetics or high frequency products, and do not leave the machine
near them.
C. Use low voltage when supplements or accessories are being adhered.
D. Be careful not to have water or coffee be spilled into the Controller and Motor.
E. Do not drop the Controller or Motor.
3) How to install the table
A. Fix the oil tub holder ①, oil holder ②,
control box ③, and main switch ④ on
the table.
Cushion Rubber
①
②
C. In case of SPS/D-B1202 series, attach the
bed cushion rubber ① and safety switch
supporting rubber ② to the table.
[ Fig. 3 ]
To Next Page
Loading...
Need help?
General
