SunStar SWF/B-T1201C - COLOR CHANGE ERRORS; ENCODER ERRORS; REPETITION ERRORS

110
LESSON: Set the needle bar order as 1-2-10-11-12, adding an offset between #10 and #11.
Press when the menu
screen shows the beginning
embroidery data.
==== NEEDLE SELECT ====
[1 ]: 1 / 1
[END] [INSERT] [DEL]
Press the number key 1
==== NEEDLE SELECT ====
[1 ]: 1 / 1
[END] [INSERT] [DEL]
Press the number key 2
==== NEEDLE SELECT ====
[12 ]: 2 / 2
[END] [INSERT] [DEL]
Press and 0 to input 10.
==== NEEDLE SELECT ====
[12A ]: 3 / 3
[END] [INSERT] [DEL]
Press and to
assign an offset between no. 10
and No.11.
==== NEEDLE SELECT ====
[12Ao ]: 4 / 4
[END] [INSERT] [DEL]
You can see the cursor moves automatically.
Needle bar no. 10 A
Needle bar no. 11 B
Needle bar no. 12 C
OFFSET +