PART NO. 690809 REV: A 28
Inspection every 6 months when in water (in addition to inspection above) See checklist for details.
Check Fluid Level, fill if needed. Fluid should be within 1” of top of reservoir when FloatLift is in
up position.
Check battery fluid levels, and fill as required with distilled water
Check battery terminals, and tighten and clean if needed
Clean Solar Panels
Inspect for heavy marine growth (more than ½”), and clean if needed
Check zincs, and replace if more than 50% deteriorated
Verify both pumps in Powerpack are functioning by operating pumps individually. (each pump is
connected to one circuit breaker, disable one pump by turning off one of the circuit breakers)
Annual Inspection (in addition to 6 month inspection)
Replace zincs and check electrical potential of structural aluminum to be more than 900mV in salt
water
Check battery condition and replace batteries every 3 years, or as needed
Inspect SunFluid annually and replace SunFluid every 4 years
Check electrolysis potential of aluminum lift structure is over 900mV
Maintenance