SM3.6kWLL - Lifelynk X3
SAFETY
This device should only be used in accordance with the instructions within this manual and in
compliance with local, regional and national laws and regulations. Only allow this device to be
installed, operated, maintained or repaired by other person(s) who have also read and understood
this manual. Ensure the manual is included with this device should it be passed to a third party.
DO NOT allow minors, untrained personnel, or person(s) suffering from a physical or mental
impairment that would affect their ability to follow this manual, install, maintain or repair
this device.
Any untrained personnel who might get near this device while it is in operation MUST be
informed that it is dangerous and instructed carefully on how to avoid injury.
General Safety Information
Safety Instructions
Be sure to read this manual thoroughly before installation.
Do not attempt to install the inverter by yourself. Installation work must be carried out in compliance
with national wiring standards and by suitably qualied personnel only.
Do not turn on the power until all installation work is complete.
Do not disassemble the inverter. If you need to repair or maintenance, contact a professional
service centre.
Always use an individual power supply line protected by a circuit breaker and operating on all wires with
a distance between contacts of at least 3mm for this unit.
The unit must be correctly grounded and the supply line must be equipped with a suitable breaker and
RCD to protect people.
Disconnect all wires before performing any maintenance or cleaning to reduce the risk of electric shock.
The unit is not explosion-proof, so it should not be installed in an explosive atmosphere.
Never touch electrical components immediately after the power supply has been turned off since the
system can still have residual energy, so electric shock may occur. Therefore, after turning off the power,
always wait 5 minutes before touching electrical components.
This unit contains no user-serviceable parts. Always consult an authorised contractor for repairs.
Ensure to follow the safety warnings listed below:
WARNING
HIGH LIFE RISK DUE TO FIRE OR ELECTROCUTION.
The Lifelynk X can only be installed by a qualied licensed electrical contractor. This is not
a DIY product.
To Next Page
Loading...
Need help?
General