Need help?Do you have a question about the SunTech ST4315 and is the answer not in the manual?
General| Accuracy | 2.5m CEP |
|---|---|
| Acquisition Time (Hot start) | 1s |
| Storage Temperature | -40°C to +85°C |
| Interface | UART |
| Protocol | NMEA 0183 |
| Update Rate | 1Hz |
| Humidity | 5% to 95% non-condensing |
| Voltage | 3.3V DC |
| Current Consumption (Acquisition) | 45mA |
| Dimensions (GPS Module) | 16mm x 12.2mm x 2.4mm |
The device has 3 operation modes, driving, parking and emergency.
AVL reports GPS and some information at predefined interval, depending on the current modes. Also, AVL sends some alerts...
Set network parameters and PIN number. Parameters like APN, User ID, Server IP are configured.
Set parameters related on report interval. Configures intervals for status reports in parking, driving, and emergency modes.
Set parameters related to device events. Includes settings for ignition, delays, and input/output behavior.
Set parameters related to SMS or Call. Configures phone numbers for SMS and calls, and SMS lock settings.
Set parameters related to reporting. Includes settings for parking lock, speed limit, power saving, and connection type.
Set some value of main voltage. Configures voltage thresholds for battery charging and vehicle battery protection.
Set motion sensor parameters. Includes settings for shock detection delay, motion thresholds, and collision gravity.
Controls some functions. Allows requesting status, resetting parameters, and preset configurations.
Procedure for inserting the SIM card into the device.
Information on using the backup battery when the main power is cut off.
Details on how the device is fixed to the vehicle.
Assembly instructions, including event cable color pin description.
Explanation of blue LED blink counts and their corresponding LTE-M1 status and possible causes.
High or low extreme temperature, low air pressure, and disposal of battery hazards.
Warning against using USB Connect; it is only for production use.
To Next Page
