SunTech ST4340 User Manual

ST4340
User Manual
Suntech International Ltd.

SunTech ST4340 Specifications

General

Brand	SunTech
Model	ST4340
Category	GPS
Language	English

Summary

Protocol Construction

Command Message Format

Report Message Format

Commands

Network Parameters Setting

Describes how to set network parameters and PIN number.

Report Parameter Setting

Details parameters for setting report intervals.

Report Parameter Details

Defines parameters like T1, T2, T3, A1, SND_DIST, T4, SMS settings.

Event Parameter Setting

Describes setting parameters related to device events.

Event Parameter Details (Output, Pulse, Baud)

Details parameters for output types, pulse settings, and baud rate.

Event Parameter Details (Ignition, Delay)

Defines ignition states and delays for idle/active modes.

LTE-M1 Parameter Setting

Describes setting parameters for LTE-M1 communication.

LTE-M1 Parameter Details (SMS_LOCK, SMS_MT1-4, IN_CALL_LOCK, CALL_MT1-5)

Details phone numbers for SMS commands, incoming/outgoing calls.

SMS and Call Parameters

Details phone numbers for SMS commands, incoming/outgoing calls.

Service Parameter Setting

Describes setting service-related parameters.

Service Parameters (Group Send, Motion Sensor)

Details group send, power disconnection, GPS antenna checks, motion sensor.

Service Parameters (Connection Type, Group Send, Motion Sensor)

Explains connection types, group send logic, and motion sensor functions.

Main Voltage Parameters

Main Voltage Parameters (Ignition Detect)

Motion Sensor Parameters

Motion Sensor Thresholds and Delays

Control Commands Overview

Introduces commands for controlling device functions.

Status Request Command

Reset Command

Command to reset all parameters to factory defaults.

Preset Command

Preset Command (PresetA)

ACK of Emergency Command

Erase All Command

Reboot Command

Command to reboot the device unit.

Installation

GPS/LTE-M1 and Battery Charger Operation Check