SunTech ST4340 - Erase All Command

ST4340 User Manual
25
[response] ST4340CMD;Res;850000;010;ReqVer;ST4340E_SAMPLE_STBASE_001
4-11-12. Erase All
● Definition : Erase all of data in buffer.
Field Definitions Unit Remark
CMD_ID “EraseAll” Erase saved all reports and disable outputs.
This is needed to initialize just before device is delivered to
a customer.
<example>
[command] ST4340CMD;850000;02;EraseAll
[response] ST4340CMD;Res;850000;010;EraseAll
4-11-13. Initialize Traveled Distance
● Definition : Initialize the travel distance.
Field Definitions Unit Remark
CMD_ID “InitDist” Set traveled distance to 0.
<example>
[command] ST4340CMD;850000;02;InitDist
[response] ST4340CMD;Res;850000;010;InitDist
4-11-14. Initialize Message Number
● Definition : Initialize the message sequence number.
Field Definitions Unit Remark
CMD_ID “InitMsgNo” Set message number to 0.