5
Power Supply
This camera support 2 power supply modes: AA battery and external power.
1. AA battery: Unlock the camera, you will find the battery compartment. which need 4
pieces 1.5V AA batteries, and make sure the battery polarity is correct.
2. At the bottom of camera, there is external power supply port, which support DC 6V 1A
power, power plug size is 3.5X1.35mm
Inserting the Memory Card
• Please prepare a Micro SD card and insert it into the camera for saving files, and
format the memory card firstly before it is inserted into camera.
• Camera support micro SD card max 32GB ,class6 or above high speed card is
better, doesn't support 64GB.
• To avoid malfunction, the memory card should be far away from water, strong
vibration, dust, hot source and direct sunlight.
• Do not insert the memory card forcibly. Please refer to the marking on the
camera.
• For the first time of use, please wait for the memory card temperature reach the
ambient temperature. The camera will be short-circuited by environment
temperature and humidity. Please protect the camera when using it outdoor. the
capacity of memory card is full, the camera will stop recording automatically.
• Press the edge of the card gently to pop-up the Micro SD card.
Basic Operation
Turn On / Off the Camera
• Switch the Mode Button to “Test"to turn on the camera.
• Switch the Mode Button to “ON” ,camera start to work after 56 seconds red flash.
• Switch the Mode Button to “Off” to turn off the camera.
To Next Page
Loading...
