Superior DRT3033 - Page 56

Operation
900285-00 11/2014
Innovative Hearth Products
Superior
TM
DRT3000 Series Direct-Vent Gas Fireplaces
56
Installing the DRT3000 Series 40” and 45” logs
The logs have notches/tabs to assist proper positioning. Upper logs rest on lower logs via notches/tabs.
Proper log placement is critical to prevent sooting. Place the logs in the gaps between flame peaks, so they
do not impinge the flames. Follow the log placement instructions precisely.
NOTE: Do not cover the burner ports.
Table 37: Aries 40 Log Set
4
5
3
2
1
Log Number Description
1 Rear Log
2 Left Front Log
3 Right Front Log
4 Left Cross Log
5 Right Cross Log
Catalog number for the entire set:
40”: F1830
45”: F1884
1. If necessary, remove the glass door (Page 57).
2. Locate the log placement brackets (Figure 54).
Figure 53: Placing log 1 Figure 54: Placing logs 2 and 3
Glowing Embers
(Do not place glowing embers over burner slots)
Right Rear Log Bracket
1
Volcanic Stone
Log Rack
3
2
3. Position rear log (1) on the left rear log bracket (Figure 54)
4. Position the left front log (2) and the right front log (3) against the log rack (Figure 55).
5. Position the left cross log (4) over the rear log (1) and left front log (2) with the front resting on the log rack
(Figure 56).
Figure 55: Placing log 4 Figure 56: Placing log 5
4
2
1
3
5
6. Position the right cross log (5) on the right rear log bracket and over right front log (3) (Figure 57).
NOTE: Fireplace shown with optional brick panels and volcanic stone installed.