Superior DRT4036TEN - Local Codes; Product Identification; Product Features

www.SuperiorFireplaces.US.com
126721-01A 5
Figure 1 - Direct Vent Fireplace
Outer
Glass Door
Log Set
Flue Collar
Top Spacer
Spacer
Nailing Flange
Lower Door/
Control Cover
Herringbone Brick
Refractories
PRODUCT IDENTIFICATION
Grate
PRODUCT FEATURES
These are a few facts that can help you un-
derstand and enjoy your direct vent replace:
• The venting system may be routed to the
outside of your home in several ways. It
may vent through the roof (vertical) or it
may vent to an outside/exterior wall (hori-
zontal). The vent pipe installation is very
important to allow for proper operation.
You must follow the venting instructions
very carefully for either vertical or horizontal
applications.
• This replace may be installed in any room
of your house provided all local codes and
these installation instructions are followed.
• Each time you turn on your replace, you
may notice some amount of condensation
on the inside of the replace glass. This
is normal and will disappear after 10-20
minutes of operation.
• Your direct vent gas fireplace system
(replace and venting) is a balanced and
sealed gas operating unit. It requires ap-
proximately 10-20 minutes of operating
time before the ame pattern stabilizes.
LOCAL CODES
Install and use replace with care. Follow all
local codes. In the absence to local codes,
use the current National Fuel Gas Code ANSI
Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269