EasyManua.ls Logo

Superior Gecko - Before You Use Your Hot Tub

Superior Gecko
33 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Fill it up
Place a garden hose into the lter area. Let your
hose run for ve minutes before pung it in
to clear out any stagnant water in the hose. It
is advisable to use a hose-ended lter/water
soener (if you are in a hardwater area). This will
ll your hot tub from the pumps and pipework
rst to prevent any airlocks in the system. It will
also make balancing water easier and to reduce
the amount of impuries that can contaminate
your water. At this point your hot tub should be
turned o at the isolator.
Fill water to recommended water level as
indicated by the minimum water level. Low water
levels can cause damage to the pump and heater
element so is good pracce to top up your hot
tub on a weekly basis. If there is no water level
indicator, you should ll your hot tub to 1 inch
above the top of the back jets.
Remove side panel and check for any leaks around
the plumbing. Occasionally ngs may come loose
during shipment. If you do detect any small leaks,
you will need to hand-ghten them straight away.
Do not use a wrench, as it can easily crack the nut
and cause the leak to worsen.
Power up
You can now re-t the side panel and turn the power
on at the isolator point. Read the control panel
secon on how to operate it. Hot tubs can take
approximately 12–24 hours to rise to temperature.
Heat me depends on size, voltage and other factors
such as outside temperature. Plug & Play hot tubs
take longer to heat than 32AMP.
Balance your water
Test and balance your hot tub water before you
introduce any sanizers. It is important to balance
prior to adding sanizers to avoid unwanted problems
such as cloudiness, discolouraon or foul-smelling
water. Also, keeping your water balanced is crucial
for longevity of the hot tub and to keep your water
clean and clear. Poor water management can result
in components degrading/failing which can invalidate
your warranty. More informaon on treang your
water can be found in the Maintenance secon.
BEFORE YOU USE
YOUR HOT TUB
The informaon within this secon is for the installaon team.
PREPARATION
| 21
IMPORTANT:
DO NOT put Chlorine Granules or Chlorine
Tablets directly into the hot tub as it will bleach
or blister the hot tub and swim spa.
Please refer to the Care & Maintenance Guide
for further informaon.