Superior Gecko - Maintenance

MAINTENANCE
Disassembly and installaon of ltraon systems
Filtraon system 1
• A ltraon barrel with a water supply pipe is
installed under the ltraon and each water hole
of the lter is connected with the pipe joint on
the lter basket tail. When disassembling the lter,
please unscrew the cover counter clockwise rst,
then catch the handle in the lter basket and put
it in a suitable place for cleaning or replacing the
lter. A ltraon barrel with water supply pipe is
installed under the ltraon. When disassembling
the lter, please pull up the cover rst and then
take out the lter core for cleaning or replacing it.
• When installing the lter, please catch the handle
on the lter and connect each water hole of the
lter with the pre-set pipe joint of the ltraon
cabin. At the same me, press the lter down in its
place. Finally, install the cover. Before starng the
jet pump, please check whether the lter system is
perfectly installed.
Filtraon systems 2
• A ltraon barrel with a water supply pipe is
installed under the ltraon. When disassembling
the lter core, please rst pull up the lter net, take
out the lter basket and then the lter for cleaning
or replacing the lter.
• When installing the lter, please catch the
handle on the lter and connect each water
hole of the lter with a pre-set pipe joint of the
ltraon cabin. At the same me, press the lter
down and then push the lter basket into its
place. At last, install the lter net. Before starng
the jet pump, please check whether the lter
system is perfectly installed.
Filtraon systems 3
• When installing the lter, please press the lter
down in its place and then connect the screw
thread joint on the lter basket tail with each
water hole of the lter. Aer that, press the lter
basket down in its place. Before starng the jet
pump, please check whether the lter system is
perfectly installed.
Check the drain valve
To drain the spa:
• Twist the cap clockwise and pull out at the
same me (A)
• Once the plug is out fully you can then spin o
the cap an clockwise (B)
• Screw on the hose pipe aachment. Connect the
hose, then push in half way to release the valve (C).
At this point the spa will start draining.
A
B
C
ENJOYING YOUR HOT TUB OR SWIM SPA
| 45