Superior Gecko - Installation and Positioning

INSTALLATION
AND POSITIONING
Unwrapping your hot tub
The informaon within this secon is for the installaon team. For further informaon on where to posion the
hot tub please read the Pre-Delivery guide.
Remove lter tray & cartridges
Slide lter face upwards, then remove lter
tray cover / take o lter lid and lter cartridges
before lling. The number of lter cartridges varies
depending on the model.
Inspect for damage
Carefully unwrap the hot tub and thoroughly inspect
it for any damage. If you noce any transit damage to
the product, please photograph the damage, keep all
paperwork/labels and contact the retailer from which
the hot tub was purchased immediately.
Wipe out excess water
Your hot tub has been thoroughly factory tested
during the manufacturing process to ensure
maximum reliability and long-term sasfacon. Wipe
out any excess water from the hot tub that may have
drained from the plumbing aer tesng and make
sure it is clean prior to lling.
Rotate jets
Check the jets are fully secure and ed into
place before using the hot tub. Each jet had a
quarter of a turn to turn the jet o and on. If you
twist the jet an clockwise harder then usual the
jet will unscrew and come out
Check pump connecon and release valves
Prior to lling your hot tub, remove the side panels
where the engine compartment and control equipment
are situated. Ensure all your pump connecons are
ght and release valves are open as they may have
shied during transit.
Check air controls
Ensure all air controls on the topside of your spa are
turned to the ‘o’ posion. Failure to turn o the air
controls will extend your heat up me dramacally.
PREPARATION
| 13