Unscrew the bolts holding the wooden packing support
to the underside of the unit and then carefully swing the
unit around on the bench and repeat for the wooden
support at the opposite end (these bolts can be re-used
also provided for this with the machine).
With the help of an assistant place the unit on its stand
taking care to line up the mounting holes in the top of
base, and then remove the Styrofoam and wooden sup-
port block from under the sanding head.
3
Using the supplied 14 mm wrench bolt the machine to
the stand from underneath using one of the supplied
hex bolts and flat washers in each corner.
Note: With the unit properly secured, level the stand and
tighten all its fasteners with a 1/2" or 13 mm socket.
Screw the height adjustment knob into the handle and
tighten it down with the supplied 14 mm wrench.
5 6
10
Slide the digital read-out (DRO) from its slot and install
the supplied batteries with the (+) side facing up.
Re-install the DRO fully into the slot and plug in the cable
from the machine.
7 8 9
4
Motor
Drum carriage
To Next Page
Loading...
