A2SDi-2C/4C/8C/8C+/12C/16C-HLN4F User's Manual
70
Restore
When this feature is set to Enabled, data is restored to NVDIMM after a system power-
up. The options are Disable and Enabled.
Erase & ARM
Select Enabled to enable erasing and arming of NVDIMM after data recovery. The op-
tions are Disabled and Enabled.
NVDIMM Battery
Inactive - charging
LAB Start Location [Fixed LAB]
LAB [0]
Size(MB) [1024]
*The feature above is not available when the Method feature is disabled.
Test NonVol Mode:
Use this feature to force a nonvolatile memory ow. The options are Disable, ADR re-
covery, ADR-C2F save, and ADR-C2F restore.
Fast Boot
Use this feature to enable or disable fast path through the memory reference code. The
options are Enabled and Disabled.
Command Address Parity
Use this feature to address the DDR4 command parity. The options are Disabled and
Enabled.
Memory Frequency
Use this feature to set the maximum memory frequency for onboard memory modules. The
options are DDR-1600, DDR-1867, DDR-2133, and DDR-2400.
MMIO Size / BMBOUND Base
Use this feature to select the memory mapped IO size and BMBOUND base setting. The
low for the two settings will always be 4GB. The options are Auto, 1024M/3072M, and
3072M/1024M.
TCL Performance
Use this feature to enable the CAS Latency (tCL) to increase memory performance. The
options are Disabled and Enabled.
Memory Preservation
Enable this feature for the memory content to be preserved through a warm reset. The
options are Disabled and Enabled.
To Next Page
Loading...
Need help?
General
