Supermicro C9Z490-PG - Page 101

Chapter 4: UEFI BIOS
101
Serial Port
This feature will Enable or Disable Serial Port 1 (COM1). Check the box to enable Serial
Port 1. The default is Checked.
Device Settings - IO=3F8h; IRQ=4;
Change Settings
This feature congures the IRQ setting for Serial Port 1 (COM1). The options for Se-
rial Port 1 are Auto, "IO=3F8h; IRQ=4", "IO=3F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12",
"IO=2F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12", "IO=3E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12",
and "IO=2E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12".
Network Conguration
Note: This submenu becomes congurable when the Onboard LAN Support (1/2) is
enabled and Onboard LAN1 Option ROM is set to EFI.
Network Conguration
Intel(R) Ethernet Connection (11 I219-V (XX:XX:XX:XX:XX:XX)
PORT CONFIGURATION
NIC Conguration
Link Speed
This feature controls the port speed used for the selected boot protocol. The options
are Auto Negotiated, 10 Mbps Half, 10 Mbps Full, 100 Mbps Half, and 100 Mbps Full.
Wake On LAN
This feature enables the system to be powered on using an in-band packet. The op-
tions are Disabled and Enabled.
Blink LEDs
Use this feature to identify a physical network port. Enter a number to force the associ-
ated network port LED to blink.
PORT CONFIGURATION INFORMATION
Information for the LAN port conguration is displayed.