Supermicro C9Z490-PG - Installation (Optional)

32
Super C9Z490-PG/-PGW User's Manual
2.5 M.2 Installation (optional)
Two M.2 M key sockets are supported by the C9Z490-PG/-PGW. M.2 devices are used for
solid state storage and internal expansion. Follow the steps below in order to install an M.2
device.
1. Locate and remove the retaining screws on the M.2
heatsinks.
2. With the heatsink removed, locate the bundled
stando󰀨 depends on the length of M.2 device if
necessary.
Note: Two stando󰀨s have been pre-installed in
the 2280 and 22110 mounting holes and de-
signed for the heatsink installation. To plug the
smaller M.2 device, please using other stando󰀨
bundled in the motherboard package.
3. Carefully plug the M.2 device into the M.2 socket
and lower the semi-circle notched end onto the
stando󰀨.