Appendix D: UEFI BIOS Recovery
141
7. After the BIOS recovery process is complete, press any key to reboot the system.
Note: It is recommended that you update your BIOS after BIOS recovery. Please refer
to Chapter 3 for BIOS update instructions.
8. Press <Del> during system boot to enter the BIOS Setup utility. From the top of the tool
bar, select Boot to enter the submenu. From the submenu list, select Boot Option #1
as shown below. Then, set Boot Option #1 to [UEFI AP:UEFI: Built-in EFI Shell]. Press
<F4> to save the settings and exit the BIOS Setup utility.
9. When the UEFI Shell prompt appears, type fs# to change the device directory path. Go
to the directory that contains the BIOS package you extracted earlier in Step 2. Enter
ash.nsh BIOSname#.### at the prompt to start the BIOS update process.
Note: Do not interrupt this process until the BIOS ashing is complete.
To Next Page
Loading...
