Supermicro C9Z490-PG - Page 35

35
Chapter 2: Installation
1. USB0/1 (USB 2.0)
2. USB2/3 (USB 2.0)
3. USB4/5 (USB 3.2 Gen 1)
4. USB6 (USB 3.2 Gen 2)
5. USB7 (USB 3.2 Gen 2)
6. USB8 (USB 3.2 Gen 2)
7. USB9 (USB 3.2 Gen 2x2)
8. USB10/11 (USB 3.2 Gen 1)
9. USB12 (USB 3.2 Gen 2)
Universal Serial Bus (USB) Ports
Two USB 3.2 Gen 1 Type A ports (USB4/5), two USB 3.2 Gen 2 Type A ports (USB6/8), one
USB 3.2 Gen 2 Type C port (USB7), and one USB 3.2 Gen 2x2 Type C port (USB9) are
located on the I/O back panel. In addition, four front panel USB 2.0 headers (USB0/1, 2/3),
one USB 3.2 Gen 1 header (USB10/11), and one USB 3.2 Gen 2 20-pin connector (USB12)
are also located on the motherboard to provide front chassis access using USB cables (not
included). Refer to the tables below for pin denitions.
Front Panel USB0/1, 2/3 (2.0)
Pin Denitions
Pin# Denition Pin# Denition
1 +5V 2 +5V
3 USB_PN2 4 USB_PN3
5 USB_PP2 6 USB_PP3
7 Ground 8 Ground
9 Key 10 Ground
Front Panel USB10/11 (3.2 Gen 1)
Pin Denitions
Pin# Pin# Signal Name Description
1 19 VBUS Power
2 18 StdA_SSRX- USB 2.0 Di󰀨erential Pair
3 17 StdA_SSRX+
4 13 Ground Ground of PWR Return
5 15 StdA_SSTX- SuperSpeed Receiver
6 14 StdA_SSTX+ Di󰀨erential Pair
7 16 GND_DRAIN Ground for Signal Return
8 12 D- SuperSpeed Transmitter
9 11 D+ Di󰀨erential Pair
Front Panel USB 12 (3.2 Gen 2)
Pin Denitions
Pin# Denition Pin# Denition Pin# Denition
1 VBUS 5 RX1+ 9 NC 13 TX2- 17 GND
2 TX1+ 6 RX1- 10 NC 14 GND 18 D-
3 TX1- 7 VBUS 11 VBUS 15 RX2+ 19 D+
4 GND 8 CC1 12 TX2+ 16 RX2- 20 CC2
PCH
PLX
Super I/O
LAN Controller
SW1 (CLEAR CMOS)
10G LAN
Controller
+
+
3
1
DESIGNED IN USA
C9Z490-PGW
REV:1.01
BIOS
LICENSE
MAC CODE
MAC CODE
BAR CODE
MH14
JRLED1
MH11
MH10
MH12
MH13
MH15
JSTBY1
JTPM1
HD AUDIO
B1
SP1
JD1
JSD1
SYS_FAN3
USB10/11 (3.2(5Gb))
JPW1
LED18
LED17
LED3
LED2
LED1
JPW2
JI2C2
JI2C1
JL1
LED4
JPAC1
JLED1
JWD1
JPME2
12V_PUMP_PWR1
USB9 (3.2(20Gb))
USB8 (3.2(10Gb))
USB2/3
JF1
BOOT LED
VGA LED
DIMM LED
CPU LED
DP/HDMI
LAN1
AUDIO FP
COM1
USB0/1
PCIE M.2-M1
CPU SLOT1 PCI-E 3.0 X8 (IN X16) CPU SLOT3 PCI-E 3.0 X16
PCH SLOT4 PCI-E 3.0 X1
CPU SLOT5 PCI-E 3.0 X8 (IN X 16)
I-SATA1
I-SATA0
I-SATA3
I-SATA2
CPU SLOT7 PCI-E 3.0 X16
SYS_FAN2
PCIE M.2-M2
USB12 (3.2(10Gb))
USB6/7 (3.2(10Gb)) USB4/5 (3.2(5Gb))
POWER
BUTTON
DIMMB1
DIMMB2
DIMMA1
DIMMA2
RESET
BUTTON
SYS_FAN1
CPU_FAN1
CLEAR CMOS
CPU_FAN2
LAN2
PCIE M.2-E1
WiFi+BT
1
8
2
9
6
7
4
5
3
Up
Down