Supermicro C9Z490-PG - Page 93

Chapter 4: UEFI BIOS
93
Re-try Boot
If this feature is enabled, the BIOS will automatically reboot the system from a specied boot
device after its initial boot failure. The options are Disabled, Legacy Boot, and EFI Boot.
Power Conguration
Watch Dog Function
If enabled, the Watch Dog Timer will allow the system to reset or generate NMI based on
jumper settings when it is expired for more than ve minutes. The options are Disabled
and Enabled.
AC Loss Policy Depend on
Use this feature to set the power state after a power outage. Select Stay O󰀨 for the system
power to remain o󰀨 after a power loss. Select Power On for the system power to be turned
on after a power loss. Select Last State to allow the system to resume its last power state
before a power loss. The options are Stay O󰀨, Power On, and Last State.
Power Button Function
This feature controls how the system shuts down when the power button is pressed.
Select 4 Seconds Override for the user to power o󰀨 the system after pressing and holding
the power button for four seconds or longer. Select Instant O󰀨 to instantly power o󰀨 the
system as soon as the user presses the power button. The options are Instant O󰀨 and 4
Seconds Override.
DeepSx Power Policies
This feature enables DeepSx Power Policy conguration. The options are Disabled and
Enabled in S4-S5.
Connectivity Conguration
Note: This submenu becomes congurable when a CNVi device is plugged into the moth-
erboard. It's already built-in in C9Z490-PGW.
Connectivity Conguration
The following information will be displayed:
• CNVi present - display the status of wireless connection
CNVi Conguration
CNVi WiFi&BT
This feature enables CNVi WiFi and Bluetooth support. The options are Disabled and
Enabled.