41
Chapter 2: Installation
PCI-E M.2 Connector (J23)
The PCI-E M.2 (J2) connector is for devices such as memory cards, wireless adapters, etc.
These devices must conform to the PCI-E M.2 specications (formerly known as NGFF). This
particular PCI-E M.2 supports M-Key (PCI-E x4) storage card.
TPM Header/Port 80 Connector (TPM Port)
The JTPM1 header is used to connect a Trusted Platform Module (TPM), which is available from
a third-party vendor. A TPM is a security device that supports encryption and authentication in
hard drives. It enables the motherboard to deny access if the TPM associated with the hard
drive is not installed in the system.
Please go to the following link for more information on TPM: http://www.supermicro.com/
manuals/other/TPM.pdf.
Trusted Platform Module Header
Pin Denitions
Pin# Denition Pin# Denition
1 LCLK 2 GND
3 LFRAME# 4 Key
5 LRESET# 6 N/C
7 LAD3 8 LAD2
9 3.3V 10 LAD1
11 LAD0 12 GND
13 SMB_CLK (optional) 14 SMB_DAT (optional)
15 P3V3_STBY 16 SERIRQ
17 GND 18 LP_CLKRUN (optional)
19 LPC_PD (optional) 20 LPC_DRQ (optional)
To Next Page
Loading...
Need help?
General
