35
Chapter 2: Installation
12~13, 15~16, 18~19 Universal Serial Bus (USB) Ports
There are two USB 3.2 Gen2 Alt Mode ports, three USB 3.2 Gen2 Type A ports, and one
USB 3.2 Gen2x2 Port on the rear I/O panel.
17. Dedicated IPMI LAN Port
One dedicated IPMI LAN port is located on the rear I/O panel. This port accepts an RJ45
type cable.
20. UID Switch and UID LED
A Unit Identier (UID SW) switch and UID LED (LED1) are located on the I/O backpanel. The
rear UID LED (LED1) is located next to the UID switch. When you press the UID switch, both
rear and front UID LED indicators will turn on. Press the UID switch again to turn o the LED
indicators. The UID Indicator provides easy identication of a system that may be in need of
service. See Section 2.6 for the front panel UID LED header location on JF1.
Note: UID can also be triggered via IPMI on the serverboard. For more information on IPMI,
please refer to the IPMI User's Guide posted on our website at http://www.supermicro.com
21. JUBUD1 Button
A JUBUD1 button on the rear I/O panel allows BIOS recovery.
JUBUD1
To Next Page
Loading...
