Supermicro H13SAE-MF - Page 42

42
Chapter 2: Installation
PCIe M.2 Connectors (M.2-C1, M.2-C2)
The PCIe M.2 connectors are for devices such as memory cards, wireless adapters, etc.
These devices must conform to the PCIe M.2 specications (formerly known as NGFF). These
particular PCIe M.2 connectors support M-Key (PCIe x2) storage cards. M.2-C1 and M.2-C2
can support a speed of PCIe 5.0.
USB Ports (USB0~1, USB8~9)
There are a total of nine USB ports supported on the motherboard. Four are located on the
front panel, and ve are located on the back panel. Note that USB devices are not able to
wake up from S3/S4 state.
Front Panel USB 0/1 (2.0)
Pin Denitions
Pin# Denition Pin# Denition
1 +5 V 2 +5 V
3 USB_N 4 USB_N
5 USB_P 6 USB_P
7 Ground 8 Ground
9 NC 10 OC
Front Panel USB 8/9 (3.0)
Pin Denitions
Pin# Denition Pin# Denition
1 +5 V
2 USB3_RN 19 +5 V
3 USB3_RN 18 USB_SSRXN
4 GND 17 USB_SSRXP
5 USB3_TN 16 GND
6 USB3_TP 15 USB_SSTXN
7 GND 14 USB_SSTXP
8 USB_N 13 GND
9 USB_P 12 USB_D-
10 GND 11 USB_D+
Onboard Battery (BT1)
The onboard back up battery is located at BT1. The onboard battery provides backup power
to the on-chip CMOS, which stores the BIOS' setup information. It also provides power to
the Real Time Clock (RTC) to keep it running.