Supermicro H13SAE-MF - Page 80

80
Chapter 4: BIOS
option will be reset to Disabled. Changes take e󰀨ect after you save settings and reboot the
system.
Notes:
• Connect a USB ash drive with the Authentication-Key (TPMAuth.bin) to your system
before conguring this feature.
• Load the Authentication-Key after installing a TPM device. The TPM function will not work
properly without an Authentication-Key.
USB Security Policy
Use this feature to congure USB Security Policy settings. When this feature has not
previously been set to Enabled, this feature will toggle whether the BIOS should automatically
save a USB Authentication-Key named "USBAuth.bin" to a USB ash drive and begin the
USB Security Policy. The options are Disabled and Enabled. Changes take e󰀨ect after you
save settings and reboot the system.
Note: Connect a USB ash drive to your system before conguring this feature. Save the
USB Authentication-Key and keep a backup.
When this feature has been previously set to Enabled, the options are Enabled and Reset. To
disable the USB Security Policy, set this feature to Reset. When this feature is set to reset,
the system and TCG NVMe devices chosen in "Super-Guardians Protection Policy" will be
in the unprotected mode.
Intel(R) I210 Gigabit Network Connection - XX:XX:XX:XX:XX:XX
Firmware Image Properties
The following information is displayed:
• Option ROM Version
• Unique NVM/EEPROM ID
• NVM Version
NIC Conguration
Use this setting to congure the network device port.
Blink LEDS
Use this setting to set blink LEDs for a duration up to 15 seconds.