Supermicro H13SSL-N - Page 82

H13SSL-N/NT User's Manual
82
iSCSI Parameters via DHCP
This setting enables the acquisition of iSCSI target parameters from DHCP. The options
include Disabled and Enabled.
CHAP Authentication
This setting enables the ability of the initiator to use CHAP authertication when connect-
ing to the iSCSI target. The options are Disabled and Enabled.
Boot to iSCSI Target
Specify whether the iSCSI initiator will boot to the specied iSCSI target after connec-
tion. One Time Disabled disables iSCSI boot for the next (current) boot, after which it is
enabled. The options are Disabled, Enabled and One Time Disabled.
DHCP Vendor ID
The default setting is BRCM ISAN.
Link Up Delay Time
This setting congures link up delay time in seconds. The default value is 0.
Use TCP Timestamp
This setting enables or disables TCP timestamp.
Target as First HDD
This setting enables or diables target appears as rst hard disk drive in the system.
LUN Busy Retry Count
This setting congures number of retries in 2 second intervals when LUN is busy. The
default value is 0.
IP Version
This setting displays whether IPv4 or IPv6 network addressing will be used for iSCSI
initiator and targets. The default setting is IPv4.
iSCSI Initiator Parameters
This setting is the conguration of iSCSI initiator parameters.
iSCSI First Target Parameters
This setting enables connection and congure communication parameters for the rst
iSCSI target.