Supermicro H13SSL-N - Page 81

Chapter 4: UEFI BIOS
81
MBA Conguration Menu
Legacy Boot Protocol
Select a non-UEFI Boot protocol. The options are PXE, iSCSI, None.
Boot Strap Type
This setting controls the boot strap method used to boot to the operating system. The
options are Auto Detect, BBS, Int 18h and Int 19h.
Hide Setup Prompt
Use this setting to congure whether setup prompt is displayed during ROM initialization.
The optionas are Disabled and Enabled.
Setup Key Stroke
Congure key strokes to invoke conguration menu. The optionas are Ctrl-S and Ctrl-B.
Banner Message Timeout
Use this setting to specify the number of seconds that the optionROM banner is displayed
during POST. The default value is 5.
Link Speed
Use this setting to congure link speed. The options are AutoNeg, 10Mbps Half, 10Mbps
Full, 100Mbps Half and 100Mbps Full.
Pre-boot Wake on LAN
Use this settiing to congure Pre-boot wake on LAN. The options include Disabled and
Enabled.
VLAN Mode
Virtual LAN mode enables use of a VLAN tag to be used by PXE. The options include
Disabled and Enabled.
iSCSI Boot Conguration Menu
iSCSI General Parameters
TCP/IP Parameters via DHCP
This option is specic to IPv4. Controls the source of the initiator IP address, DHCP or
static assignment. The options are Disabled and Enabled.