SC946ED Chassis Manual
4-14
Figure 4-15. Removing the Power Distributor Board
8. Remove the eight screws securing the power distributor board to the power
distributor bracket and set them aside for later use.
9. Pull the power distributor board off the bracket.
10. Align the mounting holes in the replacement power distributor board with
those in the power distributor bracket.
11. Secure the power distributor board to the bracket using the eight screws
previously set aside.
12. Place the power distributor assembly in the chassis and align the mounting
holes in the power distributor bracket with those in the chassis. Secure the
power assembly to the chassis with the six screws previously set aside.
13. Return the power cage to the chassis and secure it to the chassis with the
two screws previously set aside.
14. Push the power supplies into the power bays of the power module until they
click into the locked position.
15. Plug the power cords into the rear of the power supplies and power up the
system.
1
7
To Next Page
Loading...
