Supermicro SC946ED-R2KJBOD - Installing The Inner Rails on the Chassis

SC946ED Chassis Manual
5-6
Figure 5-4. Inner Rails
Installed on the Chassis
Figure 5-3. Installing
the Inner Rails
Installing The Inner Rails on the Chassis
Installing the Inner Rails
1. Remove the inner rail from the chassis accessory kit.
2. Place the inner rail rmly against the side of the chassis, aligning the hooks
on the side of the chassis with the holes in the inner rail.
3. Slide the inner rail forward toward the front of the chassis until the lock button
clicks into the locked position.
4. Press the locking tab to secure the rail into the locked position.
5. Repeat steps 1 through 4 above for the other inner rail.
3
1
4
1
5
Inner Rails
Warning: do not pick up the server by the front handles. They are designed
to pull the system from a rack only.