3-5
Chapter 3: Troubleshooting
Question: Why do I get an error message “IASTOR.SYS read error” and "press F6
to install Intel RAID driver" when installing Windows on my motherboard?
Answer: To solve this issue, disable the IPMI jumper. Another solution is to use a
USB oppy drive instead of the onboard oppy drive. For the IPMI jumper location,
please check Chapter 1.
Question: What is the heatsink part number for my X9SRi/X9SRE Series moth-
erboard?
Answer: The heatsink part numbers are as follows:
1U Passive Heatsink: SNK-P0047P
2U Passive Heatsink: SNK-P0048P
4U Active Heatsink: SNK-P0050AP4
Question: Why can't I recover the BIOS even when I’ve followed the instructions
in the user’s manual for the motherboard?
Answer: Please disable the IPMI jumper and try it again. For the jumper location,
please check Chapter 1.
To Next Page
Loading...
Need help?
General
