Supermicro SuperServer 1028GR-TR - System Installation into a Rack

2-4
SUPERSERVER 1028GR-TRT/TR User's Manual
2-5 Installing the System into a Rack
This section provides information on installing the chassis into a rack unit with the
rails provided. There are a variety of rack units on the market, which may mean
that the assembly procedure differs slightly. You should also refer to the installation
instructions that came with the rack unit you are using.
Note: 
Stability hazard. The rack stabilizing mechanism must be in place, or the
    
Failure to stabilize the rack can cause the rack to tip over.
Identifying the Sections of the Rack Rails
The chassis package includes two sets of rack rails, one set for the right side of the

to the chassis and an outer rail that attaches to the rack.
The inner rails are pre-attached and do not interfere with normal use of the chassis
if you decide not to install it into a rack.
Figure 2-1. Identifying the Sections of the Rack Rails
Inner Rail
Extension--
attach to the
chassis
Outer Rails--
slide together
Inner Rail--
pre-attached to the
chassis
Front and Rear
Brackets--
attach to the rack