1-2
SUPERSERVER 1028GR-TR/TRT User's Manual
1-2 Serverboard Features
At the heart of the server is the X10DRG-H/HT, a dual processor serverboard based
on the Intel PCH C612 chipset. Below are the main features. (See Figure 1-1 for
a block diagram)
Processors
The X10DRG-H/HT supports two Intel E5-2600 v3/v4 series processors in LGA
2011 sockets (Socket R3). Refer to the serverboard description pages on our web
site for a complete listing of supported processors (www.supermicro.com).
Memory
The serverboard has 16 DIMM slots that can support up to 2TB of registered Load
Reduced (LRDIMM), or 1 TB of RDIMM, DDR4 ECC 2400/2133/1866/1600 MHz
DIMMs. See Chapter 5 for details.
Serial ATA
The serverboard supports a 10-port SATA 3.0 subsystem. RAID 0, 1, 5 and 10 can
be enabled. The SATA drives are hot-swappable.
PCI Expansion Slots
The serverboard has four PCI-Express 3.0 x16 slots to support three double-width
slot) card. Note that both CPUs must be installed for full use of the PCIe slots.
Input/Output Ports
The rear I/O ports include a VGA (monitor) port, two USB 3.0 ports, two Ethernet
LAN ports (1Gb for X10DRG-H, 10Gb for X10DRG-HT) and one dedicated IPMI
LAN port.
IPMI
IPMI (Intelligent Platform Management Interface) is a hardware-level interface
Supermicro server platforms. IPMI allows server administrators to view a server’s
hardware status remotely, receive an alarm automatically if a failure occurs, and
power cycle a system that is non-responsive.
To Next Page
Loading...
