Supermicro SuperServer 1029P-WTR - Appendix C System Specifications

128
SuperServer 1029P-WTR User's Manual
Appendix C
System Specications
Processors
Dual Intel® Xeon® Scalable processors in a Socket P type socket
Note: 
Chipset
Intel C621 chipset
BIOS
256 MB AMI® Flash ROM
Memory
Twelve 288-pin slots that can support up to 1.5 TB of ECC DDR4-2666 RDIMM (Registered DIMM) or LRDIMM (Load-
Reduced DIMM) memory
Note: See the memory section in Chapter 3 for details and our website for updates to supported memory.
SATA Controller
On-chip (Intel C621) controller
Drive Bays
Eight 2.5" hot-swap drive bays to house eight SAS/SATA drives
PCI Expansion Slots
One PCI-Express 3.0 (x16 + x16) slot supported by CPU1 and CPU2 for left riser card (SXB1)
One PCI-Express 3.0 x16 slot supported by CPU2 for right riser card (SXB2)
One PCI-Express 3.0 x16 slot supported by CPU1 for SAS3 AOM controller (JAOM)
Motherboard
X11DDW-L; ATX form factor (12 x 13 in. / 305 x 330 mm.)
Chassis
SC113AC2-R706WB2; 1U Rackmount, 17.2 x 1.7 x 20 in. / 437 x 43 x 508 mm. (W x H x D)
System Cooling
Four 4-cm counter-rotating PWM fans
Power Supply
Model: PWS-706P-1R
AC Input Voltages: 100-240 VAC
Rated Input Current: 8.5A to 6A
Rated Input Frequency: 50-60 Hz
Rated Output Power: 700-750W
Rated Output Voltages: +3.3V (25A), +5V (25A), +12V (700W: 58A at 100V-140V, 750W: 62A at 180V-240V), -12V (0.6A),
+5Vsb (3A)
Operating Environment
Operating Temperature: 10º to 35º C (50º to 95º F)
Non-operating Temperature: -40º to 60º C (-40º to 140º F)
Operating Relative Humidity: 8% to 90% (non-condensing)
Non-operating Relative Humidity: 5% to 95% (non-condensing)