Supermicro SUPERSERVER 5018D-FN8T - Other Motherboard Connectors

Chapter 5: Advanced Motherboard Setup
5-13
Fan Header
Pin Denitions
Pin# Denition
1 Ground (Black)
2 +12V (Red)
3 Tachometer
4 PWM_Control
Fan Headers
There are six fan 4-pin headers. Pins
1-3 are backward compatible with
the traditional 3-pin fans, but you can
use 4-pin fans to take advantage of
the fan speed control using Pulse
Width Modulation through the BMC.
This allows the fan speeds to be
automatically adjusted based on the
motherboard temperature. Refer to
the table on the right for pin denitions.
Chassis Intrusion
A Chassis Intrusion header is located
at JL1 on the motherboard. Attach the
appropriate cable from the chassis
to alert a chassis intrusion when the
chassis is opened.
Chassis Intrusion
Pin Denitions (JL1)
Pin# Denition
1 Ground
2 Intrusion Input
DOM PWR Connectors (JSD1,
JSD2)
The Disk-On-Module (DOM) power
connectors (JSD1 and JSD2) provide
5V power to solid-state DOM storage
devices connected to one of the SATA
ports. See the table on the right for pin
denitions.
DOM PWR
Pin Denitions
Pin# Denition
1 5V
2 Ground
3 Ground
System Management Bus Header
A System Management Bus header
for IPMI 2.0 is located at JIPMIB1.
Connect the appropriate cable here
to use the IPMI I
2
C connection on
your system.
SMBus Header
Pin Denitions
Pin# Denition
1 Data
2 Ground
3 Clock
4 No Connection
Other Motherboard Connectors