Supermicro SUPERSERVER 5018D-FN8T - 5-10 SATA Ports

Chapter 5: Advanced Motherboard Setup
5-21
Overheat/PWR Fail/Fan Fail LED
An onboard Overheat/PWR Fail/ Fan Fail
LED is located at LED8. See the table on
the right for a description.
Overheat/PWR Fail/Fan Fail
LED States
Color/State Denition
Red/Solid Overheat
Red/Blinking PWR Fail or Fan Fail
Unit Identication LED
Unit identier (UID) LED helps identify the server in a rack. A front UID LED indicator
(LED7) is located next to the UID switch on the front I/O panel.
The UID function can be activated by the UID switch on the front I/O panel or through
IPMI. When activated, the LED is lighted blue.
5-10 SATA Ports
SATA Ports
This motherboard has six SATA 3.0 ports. I-SATA0 and I-SATA1 have built-in power
pins to support Supermicro's SATA DOM (Disk On Module) solutions.
M.2 Socket
M.2 is formerly known as Next Generation Form Factor (NGFF). The connector
(JMD1) is designed for internal mounting devices. The motherboard deploys an M
key dedicated for SSD devices with the ultimate performance capability in a PCI
Express 3.0 x4 interface for native PCIe SSD support. The M.2 is mux with the
I-SATA4 port for legacy SATA SSD devices.
Mini PCI-E Slot
The JMP1 connector is a mini PCI-E 2.0 X1 slot that is mux with I-SATA5.