Supermicro SUPERSERVER 5018D-FN8T - Page 61

Chapter 5: Advanced Motherboard Setup
5-19
10Gb Ethernet Enable/Disable
JPTG1 is used to enable or disable 10Gb
support.
10Gb Enable/Disable
Jumper Settings
Pin# Denition
1-2 Enabled (Default)
2-3 Disabled
GbE LAN Ports Enable/Disable
Jumpers JPL1 and JPL2 are used to
enable or disable LAN ports 1 and 2,
respectively. Use JPL3 to enable or
disable LAN ports 3, 4, 5, and 6. The
default setting is enabled.
GbE LAN Enable
Jumper Settings
Pin# Denition
1-2 Enabled (Default)
2-3 Disabled