SuperServer 5019P-WT/WTR User's Manual
3332
Chapter 3: Maintenance and Component Installation
Printed Triangle on Motherboard
Removing the screws in
the sequence of 4, 3, 2, 1
#1
#2
#3
#4
After removing the screws,
lift the Processor Heatsink
Module off the CPU socket.
CPU Socket
Removing the Processor Heatsink Module (PHM) from the
Motherboard
Before removing the processor heatsink module (PHM), unplug the power cord from the
power outlet.
1. Using a T30 Torx-bit screwdriver, turn the screws on the PHM counterclockwise to
loosen them from the socket, starting with the screw marked #4 (in the sequence of 4,
3, 2, 1).
2. After all four screws are removed, wiggle the PHM gently and pull it up to remove it
from the socket.
Note: To properly remove the processor heatsink module, be sure to loosen and remove the
screws on the PHM in the sequence of 4, 3, 2, 1 as shown below.
Memory Installation
Memory Support
The X11SPW-TF supports up to 192 GB of RDIMM, 384 GB of LRDIMM, and 768 GB of 3DS
LRDIMM DDR4 (288-pin) ECC memory with speeds of up to 2666 MHz in six (6) memory
slots.
Note: Check the Supermicro website for possible updates to memory support.
Important: Exercise extreme care when installing or removing DIMM modules to prevent any
possible damage.
Populating RDIMM/RDIMM 3DS/LRDIMM/LRDIMM 3DS DDR4 Memory Modules
Type
Ranks Per
DIMM and
Data Width
DIMM Capacity (GB)
Speed (MT/s); Voltage (V); Slots per Channel
(SPC) and DIMMs per Channel (DPC)
1 Slot per
Channel
2 Slots per Channel
DRAM Density 1 DPC 1 DPC 2 DPC
4 GB 8 GB 1.2 V 1.2 V 1.2 V
RDIMM SRx4 8 GB 16 GB 2666 2666 2666
RDIMM SRx8 4 GB 8 GB 2666 2666 2666
RDIMM DRx8 8 GB 16 GB 2666 2666 2666
RDIMM DRx4 16 GB 32 GB 2666 2666 2666
RDIMM 3DS
QRx4 NA 2H-64 GB 2666 2666 2666
8Rx4 NA 4H-128 GB 2666 2666 2666
LRDIMM QRx4 32 GB 64 GB 2666 2666 2666
LRDIMM 3DS
QRx4 NA 2H-64 GB 2666 2666 2666
8Rx1 NA 4H-128 GB 2666 2666 2666
Note: Visit the product page on the Supermicro website for possible updates to memory
support (www.supermicro.com).
To Next Page
Loading...
