Supermicro SuperServer 5019P-WT - System Features; Unpacking the System

98
SuperServer 5019P-WT/WTR User's Manual Chapter 1: Introduction
Chapter 1
Introduction
1.1 Overview
This chapter provides a brief outline of the functions and features of the 5019P-WT/WTR. The
5019P-WT/WTR is based on the X11SPW-TF motherboard and the 815TQC-605WB/R504WB
chassis.
In addition to the motherboard and chassis, several important parts that are included with
the system are listed below.
Main Parts List
Description Part Number Quantity
Passive Heatsink for 1U System SNK-P0067PS 1
4-cm Cooling Fan FAN-0156L4 5
Backplane BPN-SAS3-815TQ 1
Hot-swap Hard Drive Trays MCP-220-00075-0B 4
Air Shroud MCP-310-81305-0B 1
Riser Card RSC-R1UW-E8R 1
Riser Card RSC-R1UW-2E16 1
Rack Rail Mounting Kit MCP-290-00054-0N 1
1.2 Unpacking the System
Inspect the box the SuperServer 5019P-WT/WTR was shipped in and note if it was damaged

who delivered it.
Decide on a suitable location for the rack unit that will hold the server. It should be situated
in a clean, dust-free area that is well ventilated. Avoid areas where heat, electrical noise and

Be sure to read the precautions and considerations noted in Appendix B.
1.3 System Features
The following table provides you with an overview of the main features of the 5019P-WT/WTR.

System Features
Motherboard
X11SPW-TF
Chassis
815TQC-605WB/R504WB (5019P-WT/WTR, respectively)
CPU
Intel® Xeon® 81xx/61xx/51xx/41xx/31xx series with Thermal Design Power (TDP) of up to 205W and 28-cores
Note: The X11SPW-TF motherboard does not support FPGA or Fabric processors.
Socket Type
Socket P0-LGA3647
Memory
Up to 192 GB of RDIMM, 384 GB of LRDIMM, and 384 GB of 3DS LRDIMM DDR4 (288-pin) ECC memory with
speeds of up to 2666 MHz
Chipset
Intel
®
PCH C622 chipset
Expansion Slots
Two (2) full-height, full-length PCI-E 3.0 x16 slots

Hard Drives
Four 3.5" hot-swap hard drives and one (1) M.2 connector x4 (22110/2280)
Power
5019P-WT: single 600W power supply module
5019P-WTR: dual 500W power supply modules
Form Factor
1U rackmount
Dimensions
(WxHxD) 17.2 x 1.7 x 25.6 in. (437 x 43 x 650 mm)