4948
Chapter 4: Motherboard ConnectionsSuperServer 5019P-WT/WTR User's Manual
Power Button
The Power Button connection is located on pins 1 and 2 of JF1. Momentarily contacting both
button (with a setting in the BIOS - see Chapter 4). To turn off the power in the suspend
Reset Button
The Reset Button connection is located on pins 3 and 4 of JF1. Attach it to a hardware reset
Power Button
Pin Denitions (JF1)
Pins Denition
1 Signal
2 Ground
Reset Button
Pin Denitions (JF1)
Pins Denition
3 Reset
4 Ground
Power Button
UID LED
NIC1 Active LED
Reset Button
HDD LED
PWR LED
Reset
PWR
3.3V Stby
3.3V Stby
3.3V Stby
Ground
19
X
Ground
X
3.3V Stby
3.3 V
5V Stby
20
1 2
Ground
Power Fail LED
NIC2 Active LED
NMI
4.2 Front Control Panel
JF1 contains header pins for various buttons and indicators that are normally located on a
buttons and LED indicators.
HDD LED
The HDD LED connection is located on pins 13 and 14 of JF1. Attach a cable here to indicate
the status of HDD-related activities, including IDE and SATA activities. See the table below
NIC1/NIC2 (LAN1/LAN2)
The NIC (Network Interface Controller) LED connection for LAN port 1 is located on pins
11 and 12 of JF1, and the LED connection for LAN Port 2 is on Pins 9 and 10. NIC1 LED
and NIC2 LED are 2-pin NIC LED headers. Attach NIC LED cables to NIC1 and NIC2 LED
HDD LED
Pin Denitions (JF1)
Pins Denition
13 3.3V Stby
14 HDD LED
LAN1/LAN2 LED
Pin Denitions (JF1)
Pins Denition
9/11 Vcc
10/12 NIC2 Active LED/NIC1 Active LED
Power Fail LED
The Power Fail LED connection is located on pins 5 and 6 of JF1. Refer to the table below
PWR Fail LED
Pin Denitions (JF1)
Pins Denition
5 3.3V
6 Power Fail
UID LED
The UID LED is on pins 7 and 8 of JF1. Connect a cable here to show the UID activity. Refer
UID LED
Pin Denitions (JF1)
Pins Denition
7 5V Stby
8 UID LED
To Next Page
Loading...
